EN
11
operate in ambient temperatures
b5 and +32 degrees C (41
and 90 degrees F) Therefore if the
appliance is installed in an unheated/
cold room (eg: conservatory/annex/
shed/garage etc) then the appliance
will not operate causing the freezer
compartment to run warmer and as a
result the storage time of frozen food
3.
Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance
to use more electricity If installed
next to a source of heat or freezer,
maintain the following minimum side
clearances:
From Cookers 50 mm (2”)
From Radiators 300 mm (12”)
From Freezers 25 mm (1”)
4.
Make sure that sufficient room
is provided around the appliance to
ensure free air circulation. Fit the two
plastic wall spacers supplied with the
appliance onto the condenser on the
back of the appliance by rotating 1/4
turn(See Diagram).
5.
The fridge/freezer should
be located on a smooth surface.
The two front feet can be adjusted
as required. To ensure that your
appliance is standing upright adjust
the two front feet by turning
clockwise or anti-clockwise, until
the product is in firm contact with
the floor. Correct adjustment of feet
avoids excessive vibration and noise.
6.
Refer to cleaning and care
section to prepare your appliance for
use.
7.
A special receptacle is supplied
to store the mains plug during transit.
8.
The receptacle is fixed at the
back of the cabinet, on the side of
the compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.
WARNING:
Do not locate extension sockets
or charging transformers/power
supplies or Lithium-Iron battery
operated products adjacent to the
compressor as they could overheat.
