EN
13
Reversing The Doors
We recommend that you reverse
doors before switching on for the first
time.
Tools required: Small and medium size
flat and cross-headed screwdrivers, a
pair of pliers.
Spare Parts supplied in the plastic
bag: The following parts, which are
exclusively for left hand side fitted
hinge operation are supplied in a
plastic bag with the appliance:
- Upper door top trim hinge covers
– there are 2 different parts, one for
each side of top trim.
- Upper door middle hinge bushing/
door stopper assembly.
We suggest you keep all the parts
supplied in the plastic bag and also
parts, which have been removed
when reversing doors, in a safe place
for possible future, re-use.
IMPORTANT:
We suggest you ask somebody to
help you when moving the appliance
around and to hold doors when
removing / re-fitting hinges and doors
to avoid any injury and damage to the
product.
Please refer to diagrams supplied.
To follow numbers in brackets below,
refer to the main diagram.
1.
Switch off the appliance at the
socket outlet and pull out the mains
plug.
2.
Remove all loose items and
fittings and food, if any, from inside
the appliance and door racks.
3.
Gently prise off plastic hinge
cover of upper door top trim and
hinge covers on both sides of front
top panel using a small flat-headed
screwdriver. (1)
4.
Gently tilt the appliance back
against a strong wall on its rear side
sufficiently to allow the lower hinge
to be removed. Take care to protect
the appliance, your wall and floor
coverings. You can utilise the original
packaging to do this. Once you tilt the
appliance back, check to make sure
the appliance is completely stable and
safe before you carry on. (2)
5.
Unscrew and remove the
lower hinge using a cross-headed
screwdriver while holding the lower
door firmly.(3)
6.
Remove lower door carefully
off the middle hinge and stand door
upright in a safe place.(4)
7.
Open upper door and unscrew
and remove the middle hinge while
holding the upper door firmly. Use a
flat-headed screwdriver. Middle hinge
will need to be rotated 180 degrees
before re-fitting on the opposite side.
(5)
8.
Remove upper door carefully
off the upper hinge and stand door
upright in a safe place.(6)
9.
Unscrew and remove the
upper hinge using a flat-headed
screwdriver.(7)
10.
Rotate the upper hinge 180
degrees and then unscrew and
remove the hinge pin using a pair of
pliers and re-fit to opposite side of
hinge.(8)
11.
Reposition plugs and hinge
pin bushings on top of doors on the
opposite side of both doors. Use small
flatheaded screwdrivers to remove
plugs and bushings. Take care not to
mark doors.(9)
