EN
10
3
Installation
Transportation
Instructions
1.
The appliance should be
transported only in a vertical upright
position. The packing as supplied
must be intact during transportation.
2.
If during the course of
transport the appliance has to be
transported horizontally, it must only
be laid on its right hand side when
standing in the front of the appliance.
After bringing it to upright position,it
must not be operated for at least 4
hours to allow the system to settle.
3.
Failure to comply with the
above instructions could result in
damage occuring to the appliance.
The manufacturer will not be held
responsible if these instructions are
disregarded.
4.
The appliance must be
protected against rain, moisture and
other atmospheric influences.
5.
When positioning your
appliance take care not to damage
your flooring, pipes, wall coverings
etc. Do not move the appliance by
pulling by the door or handle.
6.
Empty any water in the drain
tray before moving. See section
‘Defrosting’ and ‘Care & cleaning’ for
further information.
7.
Make sure that the defrost
water pipe at the back of the product
is fixed to the plastic evaporating pan
on the top of the compressor, to avoid
defrost water spillage on the floor.
Important :
Care must be taken while cleaning
/ carrying the appliance to avoid
touching the bottom of the condenser
metal wires at the back of the
appliance as you might injure your
fingers and hands.
Do not attempt to sit or stand on top
of your appliance as it is not designed
for such use. You could injure yourself
or damage the appliance.
Important :
Make sure that mains
cable is not caught under the
appliance during and after carrying
/ moving the appliance, to avoid
the mains cable becoming cut or
damaged.”
Important :
This appliance is not designed for
stacking with any other appliance.
When positioning your appliance,
take care not to damage your flooring,
pipes,wall coverings etc.
Do not allow children to play with
the appliance or tamper with the
controls.
Beko
declines to accept any
liability should the instructions not be
followed.
Important
Installation Instructions
1.
The space in the room where
the appliance is installed must not be
smaller than 10 cubic metres.
2.
This appliance has been
designed to operate in ambient
temperatures up to 32 degrees C
(90 degrees F) and is equipped with
‘Freezer Guard’ which ensures that
