Dishwasher / User’s Manual
17 / 42
EN
Preparation
2. Fill the reservoir until “MAX” level.
3. Close the lid of the reservoir by
pressing on it lightly.
C
Wipe clean any spilled rinse aid
outside the reservoir. Rinse
aid that spilled accidentally
will cause foaming and it will
eventually decrease washing
performance.
4. Turn the rinse aid amount adjuster
manually to a position between 1 and
6 (4). If there are stains on tableware
items after washing, level must be
increased and if there is a blue trace
after wiping them by hand, it must be
decreased. This is set to position 4 as
factory default.
water softening salt
3in1:
Contains detergent, rinse aid and
water softening salt
4in1:
Contains glass protectors in addition to
detergent, rinse aid and water softening salt
5in1:
Contains glass and stainless steel
protectors in addition to detergent, rinse aid
and water softening salt
C
Observe the instructions of the
detergent manufacturer on
the package when using tablet
detergents.
When you switch to powder detergent
from tablet detergent:
1. Make sure that salt and rinse aid
reservoirs are full.
2. Set the water hardness to the highest
level and perform an empty run.
3. After the empty washing cycle, review
the user manual and readjust the water
hardness level so as to suit the water
supply.
4. Make the appropriate rinse aid settings.
C
Depending on the model,
salt indicator and/or rinse aid
indicator must be enabled again
if they were disabled before.
Rinse aid
C
The rinse aid used in
dishwashers is a special
combination used to increase
drying efficiency and prevent
water or limescale stains on the
washed items. For this reason,
care must be paid to have rinse
aid in the rinse aid reservoir
and to use rinse aids produced
specially for dishwashers only.
1. Open the lid of the rinse aid reservoir by
pressing its latch (B).
Summary of Contents for DFN28R21B
Page 44: ......