Beko DFS05C10W, User Manual

Dishwasher / User’s Manual

25 / 40

EN

Operating the product

Salt indicator

Please check the salt indicator to see 

whether there is adequate amount of 

softening salt in the dishwasher or not. 

You need to refill the salt reservoir with 

salt whenever the no-salt warning symbol 

lights.

C

Adjusting the water hardness 

level is explained in Water 

Softening System section.

Rinse Aid indicator

Please check the rinse aid indicator to see 

whether there is adequate amount of rinse 

aid in the dishwasher or not. You need to 

refill the rinse aid dispenser with rinse aid 

whenever the no rinse aid warning symbol 

lights.

Programme follow-up

You can track the current step of the 

selected programme on the programme 

step lights located on the control panel.

C

If the drying light is on, the 

machine will perform silent 

drying for 30-60 minutes. At 

the end of this period, the 

Drying light will go off and the 

End light will become on.

The End light will become on when the 

selected washing programme ends.

Cancelling the programme

1.  Press and hold the Start / Pause / 

Cancel key for 3 seconds to cancel the 

programme.

2.  Release it when the Washing and 

Drying lights start flashing. Water in 

the machine will be discharged in 45 

seconds. The programme will have 

been cancelled once the Washing and 

Drying lights go off and the End light 

becomes on. Then, you can select and 

operate a new programme.

C

There might be residues of 

detergent or rinse aid left in the 

machine and/or on the pieces 

being washed depending on the 

step in which the programme 

has been cancelled.

C

When you set the Programme 

Selection Knob to “Off” position, 

the washing programme will 

end and the machine will be 

ready for a new programme 

selection. If you end the 

washing cycle this way, water 

and detergent may remain in 

the machine.

Adjusting the amount of 

rinse aid

1.  While the Programme Selection Knob 

is in “Off” position, press and hold the 

function key and turn the Programme 

Selection Knob clockwise by one level, 

keeping the function key pressed for 

2 seconds. At the end of this time, 

the machine will enter the rinse aid 

adjustment mode. 

2.  Once the machine has entered the 

rinse aid adjustment mode, the stored 

rinse aid level will be shown on the 

programme follow-up LEDs for 5 

seconds.

3.  For the new Rinse Aid setting, set the 

Programme Selection Knob to the 

relevant position.

4.  Press Start / Pause / Cancel key for 

once to store the level you have 

selected.