Beko DFS26010B, Instruction Manual

36

EN

Lime traces remain on dishes and glassware gains a misty appearance

•  Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse 

aid if necessary. Increase the rinse aid setting if there is enough amount of 

rinse aid in the machine.

•  Water hardness setting is low or salt level is insufficient >>> Measure the 

hardness of the supply water appropriately and check the water hardness 

setting.

•  Salt leakage exists. >>> Pay attention not to spill salt around the salt filling 

hole while adding salt. Make sure that the salt reservoir lid is tightly closed 

after finishing the filling process. Run the prewash programme to remove 

the salt that spilled inside the machine. Since the salt granules that will 

remain under the lid will dissolve during prewash, causing the lid loosen, 

check the lid once again at the end of the programme. 

There is a different odour in the machine

C

  A new machine has a peculiar odour. It will fade out after a couple of was-

hing.

•  Filters are clogged. >>> Check if the filter system is clean. Clean the filter 

system regularly as illustrated in section “Cleaning and Care”.

•  Dirty dishes are kept in dishwasher for 2-3 days. >>> If you are not going 

to start the machine right after you have put the dishes into it, remove the 

remnants on the dishes and run the Prewash programme without detergent 

every 2 days. In such cases, do not close the door of the machine completely 

in order to avoid odour build up in machine. You can also use commercially 

available odour removers or machine cleaners.

Rust, discoloration or surface deterioration occurs on dishes

•  Salt leakage exists. >>> Salt may cause deterioration and oxidation on 

metal surfaces. Pay attention not to spill salt around the salt filling hole 

while adding salt. Make sure that the salt reservoir lid is tightly closed after 

finishing the filling process. Run the prewash programme to remove the 

salt that spilled inside the machine. Since the salt granules that will remain 

under the lid will dissolve during prewash, causing the lid loosen, check the 

lid once again at the end of the programme.

•  Salty food remnants have remained on dishes for a long time.  >>> If 

silverware soiled with such foods will be kept waiting in machine, dirt must 

be removed by prewash or dishes must be washed without being kept 

waiting.

•  Electric installation is not grounded. >>>Check if your machine is connected 

to the actual grounding line. Otherwise, the static electric created in the 

product causes arcs on the surfaces of metal items creating pores, removing