Dishwasher / User’s Manual
41 / 50 EN
HomeWhiz Function
HomeWhiz on/off
Press the remotestart key to enable the
function.
Product indicator when the function is
enabled.
If you press the remote start key while
the function is enabled, the Home Whiz
function will be disabled, and the product
indicator will return to the delay time/
programme time display.In the off position,
the HomeWhiz key LED will go off.
C
You can check the indicator on
the product to see if wireless
connection is enabled or not.
If the wireless connection is off,
you can see that the Wireless
icon is off.
If the Wireless icon is on,
this means that the wireless
connection of the product is on
and the product is connected
to the wireless network. If the
Wireless icon is continuously
flashing at regular intervals,
this means that it is enabled but
could not connect or is trying to
connect the network.
Wireless connection on/off
When the machine is on, press the “Menu”
key for 1 second to enter the settings
menu. Follow the screen and press <- and
+> keys on the panel, then wait until the
Wireless connection indicator comes on.
Press the selection key and if the Wireless
connection is on, turn it off; if it is off, turn
it on. In the wireless connection on/off
settings menu, if the wireless connection
is on, the Wireless connection indicator will
light permanently; if it is off, the Wireless
connection indicator will flash at short
intervals.
Once the wireless connection has been
turned “On”, your machine will connect
to the home network by using the setup
settings you made before.
Deleting the HomeWhiz settings
While the dishwasher is on, press and hold
Remote start and Menu Direction Selection
(-) keys on the panel for 5 seconds. After
the 5 - 4 - 3 - 2 - 1 countdown on the
display, your settings will be deleted.
HomeWhiz troubleshooting
Follow these instructions if you encounter a
control or connection problem. If it persists,
take the next step.
1. Check if your smart device is connected
to the internet.
2. Close the HomeWhiz application on
your smart device and start it again.
3. Restart your smart device.
4. Check the wireless connection status
of your dishwasher. If you see "WLAN:
Off", switch it to "WLAN: On" and wait
for the machine to connect. Then close
the HomeWhiz application on your
smart device and start it again.
5. If the connection cannot be established
following the instructions above,
repeat the initial setup settings on the
appliance.
6. If the problem persists, contact the
authorised service.