EN
13
4
Preparation
•
Your refrigerator should be installed at
least 30 cm away from heat sources such
as hobs, ovens, central heater and stoves
and at least 5 cm away from electrical
ovens and should not be located under
direct sunlight.
•
The ambient temperature of the room
where you install your refrigerator
should at least be 10°C. Operating your
refrigerator under cooler conditions is not
recommended with regard to its efficiency.
•
Please make sure that the interior of your
refrigerator is cleaned thoroughly.
•
If two refrigerators are to be installed side
by side, there should be at least 2 cm
distance between them.
•
When you operate your refrigerator for
the first time, please observe the following
instructions during the initial six hours.
•
The door should not be opened
frequently.
•
It must be operated empty without any
food in it.
•
Do not unplug your refrigerator. If a power
failure occurs out of your control, please
see the warnings in the “Recommended
solutions for the problems” section.
•
Original packaging and foam materials
should be kept for future transportations
or moving.
•
The baskets/drawers that are provided
with the chill compartment must always
be in use for low energy consumption and
for better storage conditions.
•
Food contact with the temperature sensor
in the freezer compartment may increase
energy consumption of the appliance.
Thus any contact with the sensor(s) must
be avoided.
•
In some models, the instrument panel
automatically turns off 5 minutes after
the door has closed. It will be reactivated
when the door has opened or pressed on
any key.