Beko DNE 65500 DE, Manual

EN

5

Placing and assembly of your refrigerator

3

• Please remember that the 

manufacturer shall not be held 

liable if the information given in the 

instruction manual is not observed. 

This product is designed for 

domestic use.

Points to be considered when 

transporting the product:

1.

 Your refrigerator must be emptied and cleaned 

prior to any transportation.

2.

 Shelves, accessories, crisper and etc. in 

your refrigerator must be fastened securely 

by adhesive tape against any jolt before 

repackaging.

3.

 Packaging must be tied with thick tapes and 

strong ropes and the rules of transportation 

printed on the package must be followed.

Please remember…

Every recycled material is an indispensable 

source for the nature and for our national 

resources.

If you wish to contribute to recycling the 

packaging materials, you can get further 

information from the environmental bodies or 

local authorities.

If the entrance door of the room where the 

refrigerator will be installed is not wide enough 

for the refrigerator to pass through, than call 

the authorized service to have them remove the 

doors of your refrigerator and pass it sideways 

through the door. 

1.

 Install your refrigerator to a place that allows 

ease of use.

2.

 Keep your refrigerator away from heat 

sources, humid places and direct sunlight.

3.

 There must be appropriate air ventilation 

around your refrigerator in order to achieve an 

efficient operation.

If the refrigerator is to be placed in a recess in 

the wall, there must be at least 5 cm distance 

with the ceiling and at least 5 cm with the wall.

If the floor is covered with a carpet, your product 

must be elevated 2.5 cm from the floor.

4.

 Place your refrigerator on an even floor 

surface to prevent jolts.

5.

 Do not keep your refrigerator in ambient 

temperatures under 10°C.

Prior to operating your refrigerator, please 

read the instruction manual carefully that 

includes important information such as 

installation, usage and maintenance of your 

product.

Preparation

Your refrigerator should be installed at least 

30 cm away from heat sources such as hobs, 

ovens, central heater and stoves and at least 5 

cm away from electrical ovens and should not be 

located under direct sunlight.

• The ambient temperature of the room where 

you install your refrigerator should at least be 

10°C. Operating your refrigerator under cooler 

conditions than this is not recommended with 

regard to its efficiency.

• Please make sure that the interior of your 

refrigerator is cleaned thoroughly.

• If two refrigerators are to be installed side by 

side, there should be at least 2 cm distance 

between them.

• Your refrigerator must run smoothly without 

any vibration. To ensure this, maintain the 

balance of your refrigerator on the floor by 

turning the adjustable front legs clockwise or 

counterclockwise. This should be done before 

the food is placed in the refrigerator.

• When you operate your refrigerator for the first 

time, please observe the following instructions 

during the initial six hours.

- Temperature adjustment button should not 

be turned off.

- The door should not be opened frequently.

- It must be operated empty without any food 

in it.

- Do not unplug your refrigerator; if a power 

failure occurs out of your control, please see the 

warnings in section “Things to be done before 

calling the authorized service”.

• Original packaging and foam materials should 

be kept for future transportations or moving.