33 / EN
Dryer / User Manual
8
Troubleshooting
Drying process takes too much time.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
• Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
• Ventilation grids on the front side of the machine are blocked. >>> Remove the objects
(if any) that block ventilation in front of the ventilation grids.
• Ventilation may not be sufficient since the room where the machine is installed is very
small. >>> Open the door and windows of the room to avoid the room temperature
increase too much.
• Lime deposit has built up on the dampness sensor.>>> Clean the dampness sensor.
• Excessive laundry was loaded in. >>> Do not overload the dryer.
• Laundry might not be spun sufficiently. >>> Spin your laundry at a higher speed in your
washing machine.
Laundry comes out wet at the end of drying.
• It is likely that the selected programme did not suit the laundry type. >>> Checking the
care labels on clothes, select appropriate programme for the laundry type or use timer
programmes in addition.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
• Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
• Excessive laundry was loaded in. >>> Do not overload the dryer.
• Laundry might not be spun sufficiently. >>> Spin your laundry at a higher speed in your
washing machine.
Dryer does not switch on or the programme does not start. Dryer does not start when it is
set.
• It might have not been plugged in. >>> Make sure that the machine is plugged in.
• The loading door is ajar. >>> Make sure that the loading door is closed securely.
• The Start / Pause button is not pressed. >>> Make sure that the programme is not in
the Pause position.
• Childproof lock might have been activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
• The loading door might not be closed securely. >>> Push the loading door to close until
you hear a locking sound.
• A power failure might have occurred. >>> Press Start / Pause button to start the
program.
• Water tank may be full. >>> Drain the water tank.
Laundry has shrunk, become felted or deteriorated.
• A programme suitable for the laundry type might have not been used. >>> Check the
garment tag and select a programme suitable for the fabric type.
Water leaks from the loading door.
• Lint has accumulated on the inner surfaces of the loading door and on the surfaces
of the loading door gasket. >>> Clean the inner surfaces of the loading door and the
surfaces of the loading door gasket.
Loading door opens spontaneously.
• The loading door might not be closed securely. >>> Push the loading door to close until
you hear a locking sound.
• Excessive laundry was loaded in. >>> Do not overload the dryer.
