Beko DRYPOINT RS 100-E HP50 NA Instructions For Installation And Operation Manual Download

Page: 11 / 72

Operating instructions in accordance with the 2014/68/EU

Pressure Equipment Directive

DRYPOINT® RS 15-550 HP50 NA

Operating instructions in accordance with the 2014/68/EU Pressure Equipment Directive

The DRYPOINT® RS 15-550 HP50 NA high pressure compressed-air refrigeration dryer contains pressure equipment
in the sense of the 2014/68/EU Pressure Equipment Directive. Therefore, the entire plant needs to be registered with the
supervisory authority if required in accordance with the local regulations.

For the examination prior to the start-up and for periodic inspections, the national regulations need to be observed, such
as the industrial safety regulation in the Federal Republic of Germany. In countries outside the EU, the respective
regulations in force there need to be adhered to.

The proper use of pressure devices is the basic requirement for safe operation. As regards pressure devices, the
following points need to be observed:

•

The DRYPOINT

RS 15-550 HP50 NA high pressure compressed-air refrigeration dryer must only be employed

within the pressure and temperature range limits indicated by the manufacturer on the name plate.

•

No welding must be carried out on the pressure parts.

•

The DRYPOINT

RS 15-550 HP50 NA high pressure compressed-air refrigeration dryer must neither be installed

in insufficiently ventilated rooms nor near heat sources or inflammable substances.

•

To avoid fractures resulting from material fatigue, the refrigeration dryer should not be exposed to vibrations during
operation.

•

The maximum operating pressure indicated by the manufacturer on the name plate must not be exceeded. It is the
installer's responsibility to install the appropriate safety and control devices. Prior to the start-up of the DRYPOINT

RS 15-550 HP50 NA high pressure compressed-air refrigeration dryer, the connected pressure generator
(compressor etc.) must be set to the max. permissible operating pressure. The integrated safeguard needs to be
checked by an approved inspection agency.

•

The documents related to the DRYPOINT

RS 15-550 HP50 NA high pressure compressed-air refrigeration dryer

(manual, operating instructions, manufacturer's declaration etc.) must be kept safe for future reference.

•

No objects whatsoever must be installed at or placed on the DRYPOINT

RS 15-550 HP50 NA high pressure

compressed-air refrigeration dryer and the connecting lines.

•

Installation of the plant in frost-free places only.

•

Operation of the plant is only permissible with fully closed and intact housing and cover panels. Operation of the
plant with damaged housing/cover panels is prohibited.

Transport

Check the packaging for visible loss or damage. If no visible damage can be ascertained, place the unit in close proximity
to the place of installation and unpack the device.

During this procedure, the dryer must always remain in an upright position. The components may be damaged when the
unit is tilted or turned upside down.

Store the device in a dry environment and do not expose it to extreme weather conditions.

Handle with care. Strong shocks can cause irreparable damage.

Storage

Keep the device away from extreme weather conditions
even when packaged.

Keep the dryer in an upright position, also while it is stored.
Tilting the device or turning it upside down can cause
irreparable damage to some components.

When  the  dryer  is  not  in  use,  it  can  be  stored  in  its
packaging  in  a  dust-free  and  protected  place  at  a
temperature of up to max. 122°F (50°C) and at a specific
humidity  of  max.  90%.  If  the  storage  period  exceeds  12
months, you should contact the manufacturer.

The packaging material is recyclable. Dispose of the material in accordance with the
directives and provisions in force in the country of destination

SCC