Beko DVTC 60 W, Installation & Operating Instructions And Drying Guidance

17

EN

Auxiliary function

Low temperature

This function allows for drying at lower 

temperatures and therefore saves energy.
Warning LED will light up when you select 
the function

.

C 

You must use this function when you 

dry your synthetic or delicate laundry.

Warning indicators

C 

Warning indicators may differ 

according to the model of your 

machine.

Filter cleaning

A warning LED will light up to remind filter 

cleaning after the programme finishes.

C 

If the filter cleaning warning LED 

lights up continuously, please refer to, 

“Solution suggestions for problems”.

Starting the Programme

1. Press “Start/Pause/Cancel” button to 

start the programme.

2. “Start/Pause/Cancel” button will light 

up to indicate that the programme has 

started.

Timer follow-up indicator

One of the LED lights will remain on as 

far as programme runs and shows the 

approximate remaining time. 

C

LEDs on the timer follow-up indicator 

will also flash when the child-proof lock 

is activated.

Changing the programme after 

the programme has started

You can use this feature to dry your 

laundry in a different programme after 

your machine has started to run.

For example;

Press and hold the “Start/Pause/Cancel” 

button for about 3 seconds to select 

“80” minutes programme instead of “60” 

minutes programme 

Select the “80” minutes programme by 

rotating the programme knob.

Press “Start/Pause/Cancel” button to 

start the programme.

C 

The programme which is selected 

first will go on even if the programme 

selection button is moved and another 

programme mode is selected while the 

machine is operating. You must cancel 

the ongoing programme in order 

to change the drying programme. 

(See, Ending the program through 

cancelling)

Adding/removing laundry in standby 

mode

In order to add or take out laundry after 

the start-up of the programme

1. Press the “Start/Pause/Cancel” button 

to switch the machine to “Pause” 

mode. Drying process will stop.

2. Open the door at Pause position and 

close it again after adding or taking out 

laundry.

3. Press “Start/Pause/Cancel” button to 

start the programme.

C

  Any laundry added after the drying 

process was started may cause the 

already dried clothes in the machine 

intermingle with wet clothes and the 

result will be wet laundry after the 

drying process is over.

C

 Laundry may be added or taken out 

as much as desired during a drying 

process, but as this process will 

interrupt drying continuously, it will 

extend the programme

 duration and increase energy 

consumption. Therefore, it is 

recommended to add laundry before 

the drying programme is started.

Child-proof lock

There is a childproof lock to prevent any 

programme interruption due to the 

pressing of keys while the programme 

is on. The loading door and all keys 

except the “On/Off” key on the panel 

are deactivated when the child-proof 

lock is active.

In order to activate the childproof lock, 

p

ress the “Start/Pause/Cancel” and “Low 

temperature” buttons simultaneously for 3 

seconds.To start a new programme after 

the programme is over or to interrupt the 

programme, the childproof lock should be 

deactivated. To deactivate the childproof 

lock, press the same buttons for 3 sec.