Beko EV 7103, User Manual

22 / EN

Washing Machine / User’s Manual 

 7 

Troubleshooting

Program does not start after closing the door.

• Start / Pause / Cancel button was not pressed.>>> *Press the Start / Pause / Cancel 

button.

Programme cannot be started or selected. 

• Washing machine has switched to self protection mode due to a supply problem 

(line voltage, water pressure, etc.). >>> To cancel the programme, turn the 

Programme Selection knob to select another programme. Previous programme will 

be cancelled.

 (See "Cancelling the programme")

Water in the machine.

• Some water might have remained in the product due to the quality control processes 

in the production. >>> 

This is not a failure; water is not harmful to the machine.

Machine vibrates or makes noise.

• Machine might be standing unbalanced. >>> 

Adjust the feet to level the machine.

• A hard substance might have entered into the pump filter. >>> 

Clean the pump filter.

• Transportation safety bolts are not removed. >>> 

Remove the transportation safety bolts.

• Laundry quantity in the machine might be too little. >>> 

Add more laundry to the 

machine.

• Machine might be overloaded with laundry. >>> 

Take out some of the laundry from the 

machine or distribute the load by hand to balance it homogenously in the machine.

• Machine might be leaning on a rigid item. >>> 

Make sure that the machine is not leaning on 

anything.

Machine stopped shortly after the programme started.

• Machine might have stopped temporarily due to low voltage. >>> 

It will resume running 

when the voltage restores to the normal level.

Programme time does not countdown. (On models with display)

• Timer may stop during water intake. >>> 

Timer indicator will not countdown until the 

machine takes in adequate amount of water. The machine will wait until there is sufficient amount 

of water to avoid poor washing results due to lack of water. Timer indicator will resume countdown 
after this.

• Timer may stop during heating step. >>> 

Timer indicator will not countdown until the 

machine reaches the selected temperature.

• Timer may stop during spinning step. >>> 

Automatic unbalanced load detection system 

might be activated due to the unbalanced distribution of the laundry in the drum. 

C

INFORMATIONS

Machine does not switch to spinning step when the laundry is not evenly distributed in the 

drum to prevent any damage to the machine and to its surrounding environment. Laundry 

should be rearranged and re-spun.