EN
9
improve the air circulation around the
appliance.
3.
Fit the two plastic wall spacers
supplied with the appliance on to
the condenser at the back of the
refrigerator by rotating 1/4 turn (see
diagram).
4.
The appliance should be located on
a smooth surface. The two front feet
can be adjusted as required. To ensure
that, your appliance is standing upright
adjust the two front feet by turning
clockwise or anti-clockwise, until the
product is in firm contact with the
floor. Correct adjustment of feet avoids
excessive
vibration and noise.
5.
Refer to “Cleaning and Care”
section to prepare your appliance for
use.
6.
This appliance has been designed
to operate in ambient temperatures
b10 and +32 degrees C
(50 and 90 degrees F).However if the
appliance is installed in an unheated /
cold room (E.g.: Conservatory /annex
/ shed / garage etc.) it will still operate
satisfactorily thanks to Freezer Guard
technology developed by Beko,down
to -15°C ambient temperature.
7.
A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the right hand side of
the compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage.
8.
The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.