EN
11
1. Switch off at the socket outlet and
pull out the mains plug.
2. Remove all food, loose items and
fittings from inside the appliance and
door shelves.
3. Carefully tilt the appliance on
its back side. (1) (You may need
somebody to help you.) Take care not
to damage the appliance by laying on
some protective material (e.g. its
original packaging). Make sure that
you tilt the appliance on its back side,
otherwise compressor oil may block
the pipes and you may damage the
appliance.
4. Unscrew and remove the LHS front
feet and bolt (2).
5. Unscrew the bolts and remove the
bottom hinge while holding the door
(3).
6. Remove the door carefully from the
top hinge by sliding downwards (4).
7. Reposition top hinge bushing and
blanking plug on the opposite side and
stand the door safely (5). You may find
it easier to remove the bushing and
the plug with the tip of a small
screwdriver. Take care not to mark the
door.
8. Reposition the top hinge on the
opposite side (6 and 7).
9. To refit the door, locate the top
hinge in the door, attach to the cabinet
and hold the door (8).
10. Fit the bottom hinge (9). If ecessary
adjust and then tighten the bolts.
Ensure, that the door opens and
closes easily and that there are no
gaps allowing air into the cabinet. If
there are gaps between the door seal
and the cabinet, adjust the door seal
by gently pulling away from the door
using fingers.
11. Fit the other front feet (10).
12. Carefully stand your appliance.
(You may need somebody to help you.)
Adjust the front feet (See Installation
Instructions)
13. Put back all, loose items and
fittings.
14. Wait for at least 4 hours to allow
the system to settle before switching
on. Spare plastic parts supplied with
the appliance are for your future use
during door repositioning.
