Beko FXS 5043S, User Manual

EN

8

3

  Installation

Transportation 

Instructions

1. 

The appliance should be 

transported only in a vertical upright 

position. The packing as supplied 

must be intact during transportation.

2. 

If during the course of 

transport the appliance has to be 

transported horizontally, it must only 

be laid on its right hand side when 

standing in the front of the appliance. 

After bringing it to upright position,it 

must not be operated for at least 4 

hours to allow the system to settle.

3. 

Failure to comply with the 

above instructions could result in 

damage occuring to the appliance. 

The manufacturer will not be held 

responsible if these instructions are 

disregarded.

4. 

The appliance must be 

protected against rain, moisture and 

other atmospheric influences.

5. 

Empty any water in the drain 

tray before moving see section 

“Defrosting” and “Cleaning & Care” for 

further information

Important : 

Make sure the plastic 

evaporating pan at the back of the 

product collects water properly. 

Important : 

 Care must be taken 

wh

i

le clean

i

ng / carry

i

ng the 

appl

i

ance to avo

i

d touch

i

ng the 

bottom of the condenser metal w

i

res 

at the back of theappl

i

ance as you 

m

i

ght 

i

njure your f

i

ngers and hands

Important : 

Th

i

s appl

i

ance 

i

s not 

des

i

gned for stack

i

ng w

i

th any other 

appl

i

ance.When pos

i

t

i

on

i

ng your 

appl

i

ance, take care not to damage 

your floor

i

ng, p

i

pes,wall cover

i

ngs etc. 

Do not move the appl

i

ance by pull

i

ng 

by the door or handle.Do not attempt 

to s

i

t or stand on top of your appl

i

ance 

as 

i

t 

i

s not des

i

gned for such use. You 

could 

i

njure yourself or damage the 

appl

i

ance.

Important :

Make sure that ma

i

ns 

cable 

i

s not caught under the 

appl

i

ance dur

i

ng and after carry

i

ng 

/ mov

i

ng the appl

i

ance, to avo

i

d 

the ma

i

ns cable becom

i

ng cut or 

damaged.”Do not allow ch

i

ldren to 

play w

i

th the appl

i

ance or tamper 

w

i

th the controls.

BEKO declines to accept any liability 

should  the  instructions  not  be 

followed.

Installation Instructions

1. 

If possible avoid placing the 

appliance near cookers, radiators or in 

direct    sunlight as this will cause the 

compressor to run for long periods. If 

installed     next to a source of heat or 

refrigerator, maintain the following 

minimum side clearances:

  From Cookers   2”   (50 mm)

  From Radiators  12” (300 mm)

  From Refrigerators or Larder Fridge        

1”   (25 mm)

2. 

No gap is required at sides 

and top. See item 3 below to ensure 

a gap is obtained at the rear of the 

appliance. If a gap is available on side 

and top, retain it if possible as it would 

improve the air circulation around the 

appliance.