Connection of the Water Pipe to
the Cold Water Mains Line
1.
Separate the nut from the tap adaptor.
(
Figure A)
2.
As shown in the figure, assemble the tap
adaptor to 1/2” valve fitting (
Figure B)
3.
As shown in the figure, after inserting the
water pipe to the nut, install it to the tap adaptor
and insert to the tap as shown in the figure.
(
Figure C)
4.
Tighten the nut manually. In case of a leak
use a spanner or a pair of pliers to tighten the
nut.
Caution:
Secure the water pipe to suitable
points by means of the pipe clips supplied to
avoid any damage or displacement or
accidental disconnection.
Caution:
After turning on the water valve,
make sure that there is no leakage at both
connection points of the water pipe. In case
of a leak, turn off the valve immediately and
tighten all joints again using a spanner or a
pair of pliers.
11
Tap Adaptor
Nut
Mesh Filter
Figure A
EN
Feed
Valve
Tap
Adaptor
Figure B
Main Cold Water Line
Nut
Water Tube
Tap
Adaptor
Figure C
Summary of Contents for GNE 46102 B
Page 1: ...GNE 46102 E GNE 46102 B GNE 46102 X No Frost ...
Page 2: ......
Page 35: ......
Page 36: ...48 5321 0000 ...