Beko HBG 60 X, User Manual

Cooker Hood / User Manual

8 / 13  EN

2 

Installing your appliance

•

Assembly and electrical connections must 
be carried out by specialized personnel.

•

Wear protective gloves before proceeding 
with the installation.

Electrical Connection:

•

The appliance has been manufactured as a 
class II, therefore no earth cable is necessary. 
The plug must be easily accessible after the 
installation of the appliance. If the appliance is 
equipped with power cord without plug, a suit-
ably dimensioned omnipolar switch with 3 mm 
minimum opening between contacts must be 
fitted between the appliance and the electricity 
supply in compliance with the load and current 
regulations.

•

The connection to the mains is carried out as 
follows:
BROWN =

 L

 line

BLUE = 

N

 neutral.

•

The minimum distance between the support 
surfaces of the cooking pots on the cooker top 
and the lowest part of the cooker hood must be 
at least 

65 cm

. If a connection tube composed 

of two parts is used, the upper part must be 
placed outside the lower part. 
Do not connect the cooker hood exhaust to the 
same conductor used to circulate hot air or for 
evacuating fumes from other appliances gener-
ated by other than an electrical source. Before 
proceeding with the assembly operations, re-
move the anti-grease filter(s) (Fig.7) so that the 
unit is easier to handle.

•

In the case of assembly of the appliance in the 
suction version prepare the hole for evacuation 
of the air.

•

We recommend the use of an air exhaust tube 
which has the same diameter as the air exhaust 
outlet hole. If a pipe with a smaller diameter 
is used, the efficiency of the product may be 
reduced and its operation may become noisier.

Please note:

If your version of the appliance has decorative 

glass before installing the hood, carry out the fol-

lowing steps as shown in 

figure 4:

1. Remove both the cooker hood body 

B

 and the 

glass panel 

A

 from the packaging and place 

them horizontally on a secure surface.

2. Take the glass panel 

A

 and position it above the 

cooker hood body 

B

.

3. Fix the glass panel securely to the cooker hood 

body using the 4 sleeves 

C

 and 4 screws 

D

 as 

indicated.

Fixing to the wall:

Drill the holes 

A

 respecting the distances indi-

cated (Fig.2). Fix the appliance to the wall and 
align it in horizontal position to the wall units. 
When the appliance has been adjusted, definitely 
fix the hood using the screws 

A

 (Fig.5). For the 

various installations use screws and screw an-
chors suited to the type of wall (e.g. reinforced 
concrete, plasterboard, etc.). If the screws and 
screw anchors are provided with the product, 
check that they are suitable for the type of wall on 
which the hood is to be fixed.

Fixing the decorative telescopic 
flue:

A

WARNING:

 If your appliance model 

features the lower connector with a 

tab, before fixing it in place bend the 

tab inwards using a pair of pliers, as 

illustrated in

 figure 5, step1.