10 / EN
Hood / User Manual
2. Into the openings, insert the screw plugs. In two
openings marked with A screw also the screws
(leaving 7 mm of screw length outside the
screw plug, Fig.5).
2 x O5 x 45mm
4 x O8 x 40mm
7mm
2 x O8 x 40mm
A
Fig.5
Screw plugs assembly
3. Screw the chimney body fastening element,
hang the hood on two untightened screws (Fig.
6).
Fig.6
Hood hanging
4
Installation
4. Open the hood cover and remove the fat filter
(Fig.7).
1
2
Fig.7
Aluminium fat filter removing
5. Place the level on the hood body. Rotating the
element marked with A, adjust the hood level
according the level’s indications, and then
tighten two screws previously screwed partially
and screw in two remaining screws (Fig. 8).
2 x O5 x 45mm
A
Fig.8
Range hood positioning
