TRANSPORTATION INSTRUCTIONS
1. The appliance should be transported only in a vertical upright position. The
packing as supplied must be intact during transportation.
2.
3. Failure to comply with the above instructions could result in damage occuring
to the appliance. The manufacturer will not be held responsible if these
instructions are disregarded.
4. The appliance must be protected against rain, moisture and other
atmospheric influences.
IMPORTANT : Care must be taken while cleaning / carrying the appliance to
avoid touching the bottom of the condenser metal wires at the back of the
appliance as you might injure your fingers and hands.
Important : This appliance is not designed for stacking with any other
appliance.
When positioning your appliance, take care not to damage your flooring, pipes,
wall coverings etc. Do not move the appliance by pulling by the door or handle.
Do not attempt to sit or stand on top of your appliance as it is not designed for
such use. You could injure yourself or damage the appliance.
"IMPORTANT: Make sure that mains cable is not caught under the appliance
during and after carrying / moving the appliance, to avoid the mains cable
becoming cut or damaged."
Do not allow children to play with the appliance or tamper with the controls.
BEKO plc declines to accept any liability should the instructions not be followed.
4
If during the course of transport the appliance has to be transported horizontally,
it must only be laid on its left hand side when standing in the front of the
appliance. After bringing it to upright position,it must not be operated for at least
4 hours to allow the system to settle.
5. Empty any water in the drain tray before moving see section “Defrosting” and
“Cleaning & Care” for further information.
IMPORTANT : Make sure the plastic evaporating pan at the back of the product
collects water properly.
IMPORTANT
INSTALLATION INSTRUCTIONS
5
1. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as
this will cause the compressor to run for long periods. If installed next to a source of heat
or refrigerator, maintain the following minimum side clearances:
2. No gap is required at sides and top. See item 3 below to ensure a gap is obtained at
the rear of the appliance. If a gap is available on side and top, retain it if possible as it
would improve the air circulation around the appliance.
3. Fit the two plastic wall spacers supplied with the
appliance rotating 1/4 turn to the condenser at the
back of the appliance (see diagram).
4. The appliance should be located on a smooth
surface. The two front feet can be adjusted as required.
To ensure that, your appliance is standing upright adjust
the two front feet by turning clockwise or anti-clockwise,
until the product is in firm contact with the floor. Correct
adjustment of feet avoids excessive vibration and noise.
5. Refer to "Cleaning and Care" section to prepare your appliance for use.
6. This appliance has been designed to operate in ambient temperatures be10
and +32 degrees C (50 and 90 degrees F).Therefore if the appliance is installed in an
unheated / cold room (E.g.: Conservatory / annex / shed / garage etc.) then the food in
the larder fridge [In particular salad, fruit, water and fruit juices] will start freezing because
of the cold ambient temperature when the temperature drops below 0 C [Zero degrees
Centigrade]. The appliance will resume normal operation when the ambient temperature
rises back above +5 C. Please note, between 0 C and +5 C, the compressor will not run
but the temperature in the larder fridge will be safe to store your food anyway. So don't
worry when the compressor does not operate between 0 C and +5 C.
7. A special receptacle is supplied to store the mains
plug during transit. The receptacle is fixed at the back
of the cabinet, on the right hand side of the compressor.
(See diagram) Gently remove the plug from the receptacle.
Never pull the mains cord, you may damage the
appliance. In the case of transportation, ensure you
locate the plug in the receptacle provided to avoid transit
damage.
8. The space in the room where the appliance is installed must not be smaller than 10 cubic
metres.
From Cookers
2" (50 mm)
From Radiators
12" (300 mm)
From Refrigerators or Larder fridges
1" (25 mm)
