EN
15
12.
Reposition left hand side feet
on the opposite side.(10)
Unscrew and remove the bottom
door hinge pin bushing/door
stopper using a cross-headed
screwdriver. (11)Unscrew and
remove the upper door middle
hinge pin bushing/door stopper
using a cross-headed screwdriver.
IMPORTANT:
This part cannot be
used on the opposite side; left hand
side middle hinge pin bushing/door
stopper part is supplied in the plastic
bag.(11)
13.
Re-fit the upper hinge on the
left hand side using flat-headed
screwdriver.(12)
14.
Fit upper door left hand side
middle hinge pin bushing/door
stopper supplied in the plastic bag
using cross-headed screwdriver.(13)
15.
Reposition three small plastic
plugs on the left hand side, which are
covering middle hinge holes, on the
opposite side to cover holes left
empty.(14)
16.
Locate and re-fit upper door to
upper hinge and hold the door firmly.
(15)
17.
Locate the middle hinge pin
to middle hinge pin bushing of upper
door on the left hand side and re-fit
the middle hinge.(16) First fit the
left screw when the door is closed
and then fit the right screw after
opening the door
for access.
18.
Reposition the screw fitted to
lower hinge hole on the left hand side
at the bottom of the cabinet on the
opposite side.(17)
19.
Locate and re-fit lower door
to middle hinge pin and then re-fit
the lower hinge on the left hand side.
(18),(19)
20.
Carefully stand the appliance
upright and adjust the two front feet
if necessary.
21.
Check that doors open and
close easily, they are aligned correctly
and that there are no gaps allowing
ir into the cabinet. If there are gaps
between the door seal and the
cabinet, adjust the door seal by gently
pulling away from the door using
fingers.
22.
Check that all the hinge screws
are tightened. Avoid over tightening
the screws.
23.
Put all items, fittings back in
the appliance.
24.
Fit upper door top trim and
front top panel plastic hinge covers.
Upper door top trim hinge covers are
supplied in the plastic bag.(20)
25.
Wait for at least 4 hours to
allow the system to settle before
switching on.
26.
Once the correct storage
temperatures have been reached in
the appliance, put back all the food.
