11 / 36 EN
Refrigerator/User Manual
4
Installation
4.1 Appropriate
Installation Location
Contact an Authorized Service for the
installation of the product. In order to
prepare the product for use, refer the
information in the user manual and
ensure that electrical installation and
water installation are appropriate. If not,
call a qualified electrician and technician
to have any necessary arrangements
carried out.
B
WARNING:
Manufacturer shall
not be held l
i
able for damages
that may ar
i
se from procedures
carr
i
ed out by unauthor
i
zed
persons.
B
WARNING
:
Product must
not be plugged
i
n dur
i
ng
i
nstallat
i
on. Otherw
i
se, there
i
s the r
i
sk of death or ser
i
ous
i
njury!
A
WARNING:
If the door clearance of the
room where the product shall
be place
i
s so t
i
ght to prevent
pass
i
ng of the product, remove
the door of the room and pass
the product through the door
by turn
i
ng
i
t to
i
ts s
i
de;
i
f th
i
s
does not work, contact the
author
i
zed serv
i
ce.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as hobs,
heater cores and stoves and at least 5
cm away from electrical ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Appropriate air ventilation must be
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in
the wall, pay attention to leave at least
5 cm distance with the ceiling and side
walls.
•
Your product requ
i
res adequate a
i
r
c
i
rculat
i
on to funct
i
on eff
i
c
i
ently.
If the product w
i
ll be placed
i
n an
alcove, remember to leave at least 5
cm clearance between the product
and the ce
i
l
i
ng, rear wall and the s
i
de
walls.
•
If the product w
i
ll be placed
i
n an
alcove, remember to leave at least 5
cm clearance between the product
and the ce
i
l
i
ng, rear wall and the
s
i
de walls. Check
i
f the rear wall
clearance protect
i
on component
i
s
present at
i
ts locat
i
on (
i
f prov
i
ded
w
i
th the product). If the component
i
s not ava
i
lable, or
i
f
i
t
i
s lost or fallen,
pos
i
t
i
on the product so that at least
5 cm clearance shall be left between
the rear surface of the product and
the wall of the room. The clearance
at the rear
i
s
i
mportant for eff
i
c
i
ent
operat
i
on of the product.
