9 / EN
Freezer/User Manual
3
Installation
3.1. Appropriate
installation location
Contact an Authorized Service
for the installation of the product.
In order to prepare the product
for use, refer the information in
the user manual and ensure that
electrical installation and water
installation are appropriate. If
not, call a qualified electrician and
technician to have any necessary
arrangements carried out.
B
WARNING: Manufacturer
shall not be held liable for
damages that may arise from
procedures carried out by
unauthorized persons.
B
WARNING: Product must
not be plugged in during
installation. Otherwise, there
is the risk of death or serious
injury!
A
WARNING:
If the door clearance of the
room where the product shall
be place is so tight to prevent
passing of the product,
remove the door of the
room and pass the product
through the door by turning
it to its side; if this does not
work, contact the authorized
service.
• Place the product on an even
floor surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as
hobs, heater cores and stoves
and at least 5 cm away from
electrical ovens.
• Product must not be subjected
to direct sun light and kept in
humid places.
• Appropriate air ventilation must
be provided around your product
in order to achieve an efficient
operation. If the product is to
be placed in a recess in the wall,
pay attention to leave at least 5
cm distance with the ceiling and
side walls.
3.2. Installing the
plastic wedges
Plastic wedges supplied with the
product are used to create the
distance for the air circulation
between the product and the rear
wall.
1.
To install the wedges, remove the
screws on the product and use the
screws supplied together with the
wedges.
2.
Insert the 2 plastic wedges onto
the rear ventilation cover as
illustrated in the figure.
Summary of Contents for RFNK290E23S
Page 2: ......
Page 23: ...23 EN Freezer User Manual ...
Page 50: ...50 RU Морозильник Руководство по эксплуатации ...
Page 52: ...www beko ru ...