Beko RRN 2260, Instruction Manual

en

en

Replacing the interior
light bulb 

(Fig. 3)

Should the light fail to work, proceed as follows.

1- Switch off at the socket outlet and pull 

out the mains plug.

You may find it useful to remove shelves for 

easy access.

2- Use a flat tipped screwdriver to remove the 

light diffuser cover.

3- First check that the bulb hasn’t worked loose 

by ensuring it is screwed securely in the holder. 

Replace the plug and switch on.

If the bulb works, replace the light cover by 

inserting the rear lug and pushing up to locate 

the front two lugs.

4- If the light still fails to work, switch off at the 

socket outlet and pull out the mains plug. 

Replace the bulb with a new 15 watt (max) 

screw cap (SES) bulb.

5- Carefully dispose of the burnt-out light bulb 

immediately.

Replacement light bulb can easily be obtained 

from a good local electrical or DIY store.

Cleaning and care

Interior and Exterior Surfaces

Attention

Always unplug the power supply or shut 
off or remove the fuse before cleaning.

Clean the exterior using lukewarm water and 
a mild detergent.

Never use detergents, abrasive or acidic 
agents.

Wipe the inside compartment dry.

Be careful to prevent water from getting into 
contact with the electrical connections of the 
temperature control or the interior light.

If the device is not going to be used for a long 
period of time, switch it off and remove all food. 
Clean the device and keep the door open.

To preserve the appearance of your device, 
you can polish the exterior and the door 
accessories with a silicone wax.

Clean the condenser at the back of the device 
once a year using a brush or a vacuum cleaner. 
Dust build-up leads to increased energy 
consumption.
Inspect the door gasket at regular intervals.
Clean with water only, and wipe totally dry.

Cleaning of the accessories 

Door shelves:

Remove all food from the door shelves.
Lift the cover of the shelf upwards and pull it 
off sideward.
Remove the bottom of the door shelf by 
pushing it upwards.

Collecting container (Pan):

Make sure that the pan at the back of the 
device is always clean.
Gently release the snap of the pan from the 
compressor by pushing it using a tool (like 
screwdriver), so that the pan can be removed.

Lift the pan, clean it and wipe it dry.
Re-assemble in reverse order.

Crisper or Drawers: 

To clean a drawer, pull it out as far as possible, 
tilt it upwards and then pull it out completely.

7