7
EN
3
Installation
B
In case the information which are
given in the user manual are not taken
into account, manufacturer will not
assume any liability for this.
Points to be paid attention
to when the relocation of the
refrigerator
1.
Your refrigerator should be
unplugged.
Before transportation of
your refrigerator, it should be
emptied and cleaned.
2.
Before it is re-packaged, shelves,
accessories, crisper, etc. inside
your
refrigerator should be fixed
with
adhesive tape and secured
against
impacts. Package should
be bound
with a thick tape or
sound ropes and
the transportation
rules on the
package should be
strictly
observed.
3.
Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the
refrigerator
Check the following before you
start to use your refrigerator:
1. Is the interior of the refrigerator dry.
and can the air circulate freely in the
rear of it?
2. Attach 2 plastic wedges as
illustrated below. Plastic wedges
are
intended to keep the distance
which
will ensure the air circulation
between your refrigerator and the
wall. (The picture is drawn up as a
representation and it is not identical
with your product.)
3. Clean the interior of the refrigerator
as recommended in the
“Maintenance and cleaning” section.
4. Connect the plug of the refrigerator
to the wall socket. When the fridge
door is opened, fridge internal lamp
will turn on.
5. When the compressor starts to
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give rise
to noise, even if the compressor is not
running and this is quite normal.
6. Front edges of the refrigerator may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
Electrical connection
Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
The connection must be in compliance
with national regulations.
• The power plug must be easily
accessible after installation.
• Electrical safety of your refrigerator
shall be guaranteed only if the earth
system in your house complies with
standards.
• The voltage stated on the label
located at left inner side of your
product should be equal to your
network voltage.
•
Extension cables and multi plugs
must not be used for connection.
