EN
8
3
Installation
Transportation Instructions
1.
The appliance should be transported
only in a vertical upright position. The
packing as supplied must be intact
during transportation.
2.
If during the course of transport the
appliance has to be transported
horizontally, it must only be laid on its
right hand side when standing in the
front of the appliance. After bringing
it to upright position,it must not be
operated for at least 4 hours to allow
the system to settle.
3.
Failure to comply with the above
instructions could result in damage
occuring to the appliance. The
manufacturer will not be held
responsible if these instructions are
disregarded.
4.
The appliance must be protected
against rain, moisture and other
atmospheric influences.
5.
Empty any water in the drain
tray before moving see section
“Defrosting” and “Cleaning & Care”
for further information
IMPORTANT :
Make sure the plastic
evaporating pan at the back of the
product collects water properly.
IMPORTANT:
Care must be taken
while cleaning / carrying the appliance
to avoid touching the bottom of the
condenser metal wires at the back of
theappliance as you might injure your
fingers and hands.
IMPORTANT:
This appliance is not
designed for stacking with any other
appliance.When positioning your
appliance, take care not to damage
your flooring, pipes,wall coverings etc.
Do not move the appliance by pulling
by the door or handle.Do not attempt
to sit or stand on top of your appliance
as it is not designed for such use. You
could injure yourself or damage the
appliance.
IMPORTANT:
Make sure that
mains cable is not caught under the
appliance during and after carrying
/ moving the appliance, to avoid
the mains cable becoming cut or
damaged.”Do not allow children to play
with the appliance or tamper with the
controls.
BEKO declines to accept any liability
should the instructions not be followed.
Installation Instructions
1.
If possible avoid placing the appliance
near cookers, radiators or in direct
sunlight as this will cause the
compressor to run for long periods.
If installed next to a source of heat
or refrigerator, maintain the following
minimum side clearances:
From Cookers 2” (50 mm)
From Radiators 12” (300 mm)
From Refrigerators or Larder Fridge
1” (25 mm)
2.
No gap is required at sides and top.
See item 3 below to ensure a gap is
obtained at the rear of the appliance.
If a gap is available on side and
top, retain it if possible as it would
improve the air circulation around the
appliance.
