Beko VOLTAS WFL6010VPWW, User Manual

Washing Machine / User Manual

19 / EN

To activate the Child Lock:

Press and hold Speed and Delayed Start buttons for 3 seconds. While you are holding for 3 seconds, 

the "Child Lock Enabled LED" will flash. You can release the buttons when the LEDs become 

permanently on.

To deactivate the Child Lock:

Press and hold Speed and Delayed Start buttons for 3 seconds while any programme is running. 

While you are holding for 3 seconds, the "Child Lock Enabled LED" will flash. You can release the 

buttons when the LED turns off completely.

C

In addition to the method above, to deactivate the Child Lock, switch the Programme Selection knob to On / Off 

position when no programme is running, and select another programme.
Child Lock is not deactivated after power failures or when the machine is unplugged.

4.3.12 Progress of programme

Progress of a running programme can be followed from the Programme Follow-up indicator. At 

the beginning of every programme step, the relevant indicator light will turn on and light of the 

completed step will turn off.

You can change the speed settings without stopping the programme flow while the programme is 

running. To do this, the change you are going to make must be in a step after the running programme 

step. If the change is not compatible, relevant lights will flash for 3 times.

C

If the machine does not proceed to the spinning step, the Rinse Hold function might be active or the automatic 

unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the 

machine.

4.3.13 Loading door lock

There is a locking system on the loading door of the machine that prevents opening of the loading 

door in cases when the water level is unsuitable.

Loading door light will start flashing when the machine is switched to Pause mode. The machine 

checks the level of the water inside. If the level is suitable, the Loading Door light turns off and the 

loading door can be opened within 1-2 minutes. 

If the level is unsuitable, the Loading Door light remains on and the loading door cannot be opened. 

If you are obliged to open the Loading Door while the Loading Door light is on, you must cancel the 

current programme. See. "Cancelling the programme" 

4.3.14 Changing the selections after programme has started

Switching the machine to pause mode

Press the Start / Pause button to switch the machine to pause mode while a programme is running. 

The light of the step which the machine is in starts flashing in the Programme Follow-up indicator to 

show that the machine has been switched to the pause mode. 

Additionally, when the loading door is openable, the Loading Door light turns off completely.

Changing the speed settings

You can change the speed settings of the programme that is currently running. See "Speed 

selection". 

C

If no change is allowed, the relevant light will flash 3 times.