Beko WDA 105614, User Manual

User’s Manual

31 / EN

Maintenance and cleaning

6.3 Cleaning the air suction filter

To clean the air suction filter:
Unplug the machine.

1

2

3

4

5

1  Attach the rear of the tool supplied in the Operation Manual bag to the place on the filter cap illustrated in Fig. 1.

2  Pull the filter cap towards yourself with the help of a finger after pulling the latch leftwise with the back side of the appartus as illustrated 

in Fig. 2.

3  Filter cap will come out easily.

4  Wash the filter cap.

5  Replace the filter cap and make sure that it seats well. If not seated twist the latch to the right with the help of the apparatus.

A

CAUTION

¾

Never use sponge or scrub materials. These will damage the painted and plastic surfaces.

¾

After every 50 washing and drying operation (approx. 3 months), clean the air suction filter of the machine.

¾

If the machine is operated only for drying for 10 times in a row, always perform an empty washing afterwards 

by using 1 short programme.

6.4 Cleaning the body and control panel

Wipe the body of the machine with soapy water or non-corrosive mild gel detergents as necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the control panel.

6.5 Cleaning the water intake filters

There is a filter at the end of each water intake valve at the rear of the machine and also at the end of each water intake hose where they are 

connected to the tap. These filters prevent foreign substances and dirt in the water to enter the washing machine. Filters should be cleaned as 

they do get dirty.
1  Close the taps.

2  Remove the nuts of the water intake hoses to access the filters on the water intake valves. Clean them with an appropriate brush. If the 

filters are too dirty, take them out by means of pliers and clean them.

3  Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under running water.

4  Replace the gaskets and filters carefully in their places and tighten the hose nuts by hand.

6.6 Draining remaining water and cleaning the pump filter

The filter system in your machine prevents solid items such as buttons, coins and fabric fibers clogging the pump impeller during discharge of 

washing water. Thus, the water will be discharged without any problem and the service life of the pump will extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned whenever it is clogged or in every 3 months. Water must 

be drained off first to clean the pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house) and in case of freezing of the water, water may have to be 

drained completely.

A

CAUTION

¾

Foreign substances left in the pump filter may damage the machine or may cause noise problem.

¾

If the product is not in use, turn the tap off, detach the supply hose and drain the water inside the machine 

against any freezing possibility in the region of installation.

¾

After each use close the supply hose tap of the product. 

6.6.1 In order to clean the dirty filter and discharge the water:

1.  Unplug the machine to cut off the supply power.