Beko WM 6103 W, Installation & Operating Instructions Manual

11

EN

fuse.

•  The specified voltage must be equal to 

your mains voltage.

•  Do not make connections via extension 

cables or multi-plugs.

B

 Damaged power cables must be 

replaced by the Authorized Service 

Agents.

Electrical requirements 

Before you insert the plug into the wall 

socket make sure that the voltage and 

the frequency shown in the rating label 

corresponds to your electricity supply.

We recommend that this appliance be 

connected to the mains supply via a 

suitable switched and fused socket in a 

readily accessible position.

Should the mains lead of the appliance 

become damaged or need replacing at 

any time, it must be replaced by a special 

purpose made mains lead which can only 

be obtained from a Authorised Service 

Agent.

B 

This appliance must be earthed

If the fitted moulded plug is not suitable for 

your socket, then the plug should be cut off 

and an appropriate plug fitted.

Destroy the old plug, which is cut off as 

a plug with a bared cord could cause a 

shock hazard if inserted into a socket 

elsewhere in the house.

The moulded plug on this appliance 

incorporates a 13A fuse. Should the fuse 

need to be replaced an ASTA approved 

BS1362 fuse of the same rating must be 

used. Do not forget to refit the fuse cover. 

In the event of losing the fuse cover, the 

plug must not be used until a replacement 

fuse cover has been fitted. Colour of the 

replacement fuse cover must be the same 

colour as that visible on the pin face of the 

plug. Fuse covers are available from any 

good electrical store.

Important

Fitting a different plug

As the colours of the wires in the mains 

lead of this appliance may not correspond 

with the coloured markings identifying the 

terminals on your plug, proceed as follows:

1  Connect the green - yellow or green 

(earth) wire to the terminal in the plug 

marked ‘E’ or with the symbol f or 

coloured green and yellow or green.

2  Connect the blue (neutral) wire to the 

terminal in the plug marked ‘N’ or 

coloured black.

3  Connect the brown (live) wire to the 

terminal in the plug marked ‘L’ or 

coloured red.

With the alternative plugs a 13A fuse must 

be fitted either in the plug or adaptor or in the 

main fuse box. If in doubt contact a qualified 

electrician.

First use

Before starting to use the product, make 

sure that all preparations are made in 

accordance with the instructions in 

sections "Important safety instructions" and 

"Installation".

To prepare the product for washing laundry, 

perform first operation in Drum Cleaning 

programme. If your machine is not 

featured with Drum Cleaning programme, 

use Cottons-90 programme and select 

Additional Water or Extra Rinse auxiliary 

functions as well. Before starting the 

programme, put max. 100 g of powder