Beko WM 6103 W, Installation & Operating Instructions Manual

29

EN

7 

Troubleshooting

Programme cannot be started or selected. 
•  Washing machine has switched to self protection mode due to a supply problem 

(line voltage, water pressure, etc.). >>> 

Press and hold Start / Pause / Cancel 

button for 3 seconds to reset the machine to factory settings. (See "Canceling the 

programme")

Water in the machine.
•  Some water might have remained in the product due to the quality control 

processes in the production. >>> 

This is not a failure; water is not harmful to the 

machine.

There is water leaking from the bottom of the washing machine.
•  Likely problems with hoses or the pump filter. >>> 

Be sure the seals of the water 

inlet hoses are securely fitted. Attach the hose to the tap tightly.

•  Pump filter might not be closed fully. >>> 

Make sure that the pump filter is 

completely closed.

Machine does not fill with water.
•  Tap is turned off. >>> 

Open the inlet water taps fully.

•  Water inlet hose is bent. >>> 

Flatten the water inlet hose.

•  Water inlet filter is clogged. >>> 

Clean the water inlet filter.

•  The loading door is ajar. >>> 

Close the Loading Door.

Machine does not drain water.
•  Water drain hose might be clogged or twisted. >>> 

Clean or flatten the hose.

•  Pump filter is clogged. >>> 

Clean the pump filter.

Machine vibrates or makes noise.
•  Machine might be standing unbalanced. >>> 

Adjust the feet to level the machine.

•  A hard substance might have entered into the pump filter. >>> 

Clean the pump 

filter.

•  Transportation safety bolts are not removed. >>> 

Remove the transportation safety 

bolts.

•  Laundry quantity in the machine might be too little. >>> 

Add more laundry to the 

machine.

•  Machine might be overloaded with laundry. >>> 

Take out some of the laundry 

from the machine or distribute the load by hand to balance it homogenously in the 

machine.

•  Machine might be leaning on a rigid item. >>> 

Make sure that the machine is not 

leaning on anything.

Machine stopped shortly after the programme started.
•  Machine might have stopped temporarily due to low voltage. >>> 

It will resume 

running when the voltage restores to the normal level.

Machine directly discharges the water it takes in.
•  Draining hose might not be at adequate height. >>> 

Connect the water draining 

hose as described in the operation manual.

No water can be seen in the machine during washing.

C

 The water level is not visible from outside of the washing machine. This is not a 

failure.