Beko WMA 727 S, Installation & Operating Instructions Manual

EN

24

Preparation

1.  Turn the tap on completely. Check if 

the hoses are connected tightly.

2.  Place the laundry in the machine.

3.  Add detergent and softener.

Starting

1.  Press the “On/Off” button (Figure 

2-14).

2.  Select the program and the 

temperature.

3.  If desired (according to your 

machine’s model):

–  select any auxiliary function,

–  adjust the spin speed,

–  set the time delay,

4.  Close the loading door.

5.  Press “Start/Pause/Cancel” button 

(Figure 2-10).

The display shows the time remaining 

for the program to complete if time delay 

is not set.

The display shows the time remaining 

for the program to start if the time delay 

is set.

6.  Check if the Door Locked Symbol 

(Figure 3-13i) lights up on the 

screen.

The Door Locked Symbol (Figure 3-13i) 

will light up if time delay is not set.

The Door Locked Symbol (Figure 3-13i) 

will fade if time delay is set.

Cancelling a program

1.   Press and hold the “Start/Pause/

Cancel” button (Figure 2-10) for 

about 3 seconds; the Start symbol 

(Figure 3-13j) will start flashing.

2.  The machine can discharge all 

the water or can take in water for 

3 times at most to cool down the 

clothes and complete discharging 

process.

Adding more laundry

•

  This is only possible under the 

following conditions:

–   during time delay,

C

  You may add or remove laundry 

during the time delay (until the 

program starts). At the beginning 

of a washing cycle (machine allows 

adding more laundry during a future 

step only if the water level is low 

enough to open the loading door or 

if the temperature in the machine is 

low).

In order to add laundry after the 

start-up of the program:

1.  Press “Start/Pause/Cancel” button 

(Figure 2-10).

2.  Open the loading door and put in 

more laundry.

3.  Close the loading door.

4.  Press “Start/Pause/Cancel” button 

(Figure 2-10).

Program is in rinse hold mode

C

  This process is shown with the 

flashing spin symbol (Figure 3-13c) 

and the standby symbol (Figure 

3-13k) which is lit up.

If you wish to spin when the machine is 

in this mode:

1.   Adjust the spin speed.

2.   Press “Start/Pause/Cancel” 

button (Figure 2-10). The program 

continues, pumps out the water and 

spins. 

3.  The standby symbol (Figure 3-13k) 

fades out and the start symbol 

(Figure 3-13j) lights up.

If you want to discharge the water 

without spinning:

1.   Press “Start/Pause/Cancel” button 

(Figure 2-10).

2.  The standby symbol (Figure 3-13k) 

fades out and the start symbol 

(Figure 3-13j) lights up.

3.  The program continues and only 

pumps out the water.

Re-spinning the laundry

The control system for an unbalanced 

load can pause the spinning in cases 

when the distribution of the laundry in 

the drum is not balanced.

If  you want to re-spin the clothes:

1.   Distribute the laundry in your 

machine for a balanced load.

2.   Select the spin program.

3.   Adjust the spin speed.

6 

 Quick instructions for daily use