Beko WMA 727 S, Installation & Operating Instructions Manual

EN

27

•  If the filters are very dirty, you can 

pull them out by means of pliers and 

clean them.

•  Take out the filters on the flat 

ends of the water intake hoses 

together with the gaskets and clean 

thoroughly under streaming water.

•  Replace the gaskets and filters 

carefully and tighten the hose nuts 

by hand.

Draining any remaining water 

and cleaning the pump filter

Filter system in your machine prevents 

solid items such as buttons, coins and 

fabric fibers clogging the pump propeller 

during discharging of the washing water.

•   If your machine fails to drain the 

water, the pump filter may be 

clogged. You may have to clean 

it every 2 years or whenever it is 

blocked plugged. Water must be 

drained off to clean the pump filter. 

In addition, water may have to be 

drained off completely in the following 

cases:

•   before transporting the machine 

(e.g. when moving house)

•   when there is the danger of frost

In order to clean the dirty filter and 

discharge the water;

1- Disconnect or unplug the machine 

from the power supply.

A 

There may be water at 90°C in the 

machine. Therefore, the filter must 

be cleaned only after the inside 

water is cooled down to avoid 

hazard of scalding.

2- Open the filter cap. The filter cap 

may be composed of one or two pieces 

according to the model of your machine.

If it is composed of two pieces, press 

the tab on the filter cap downwards and 

pull the piece out towards yourself.

If it is composed of one piece, hold it 

from both sides and open it by pulling 

out.

3- An emergency drain hose is supplied 

with some of our models. Others are not 

supplied with this item.

If your product is supplied with an 

emergency drain hose, do the following 

as shown in the figure below:

•   Pull out the pump outlet hose from 

its housing.

•   Place a large container at the end of 

the hose. Drain the water off into the 

container by pulling out the plug at 

the end of the hose. If the amount 

of water to be drained off is greater 

than the volume of the container, 

replace the plug, pour the water out, 

then resume the draining process.

•   After draining process is completed, 

replace the plug into the end of the 

hose and fit the hose back into its 

place.