15 / EN
Washing Machine / User’s Manual
4.4.5 Connecting the drain hose to the drain
• Attach the end of the drain hose directly to waste water drain, lavatory or bathtub.
A
CAUTION:
Your drain house will be flooded if the hose comes out of its housing during
water discharge. Moreover, there is risk of scalding due to high washing temperatures! In
order to prevent such situations and make sure that the machine performs water intake and
discharge processes without any problem, fix the drain hose securely.
• Connect the drain hose to a minimum height of 40 cm and a maximum height of 100 cm.
• In case the drain hose is elevated after laying it on the floor level or close to the ground
(less than 40 cm above the ground), water discharge becomes more difficult and the
laundry may come out excessively wet. Therefore, follow the heights described in the
figure.
100cm
40cm
• To prevent the waste water to go back into the machine again and to ensure easy
drainage, do not immerse the end of the hose into the waste water or do not insert it
into the drain for more than 15 cm. If it is too long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose must
not be pinched between the drain and the machine.
• If the length of the hose is too short, use it by adding an original extension hose. Length
of the hose may not be longer than 3.2 m. To avoid water leak failures, the connection
between the extension hose and the drain hose of the product must be fitted well with
an appropriate clamp as not to come off and leak.
