EN / 60
Washing Machine / User’s Manual
13.5.1 Cleaning dirty filters
CAUTION!
• Temperature of the water inside the product may rise up
to 90ºC. To avoid the risk of scalding, clean the filter after
the water inside the product has cooled down.
a) Unplug the product.
b) Open the filter cap.
c) Proceed as follows for draining water.
- Pull the emergency draining hose out from its seat.
- Place a large container at the end of the hose. Drain the
water into the container by pulling out the plug at the
end of the hose. When the container is full, block the inlet
of the hose by replacing the plug. After the container is
emptied, repeat the above procedure to drain the water
in the product completely.
- When draining of water is finished, close the end by the
plug again and fix the hose in its place.
- Turn the pump filter to take it out.
d) Clean any residues inside the filter as well as fibers, if any, around
the pump impeller region.
e) Install the filter.
f) Close the filter cover.
