Beko WTG50M1W, User Manual

29 / EN

Washing Machine / User’s Manual

4.6.10 Starting the programme

1. Press Start / Pause button to start the programme.

2. Programme follow-up light showing the startup of the programme will turn on.

4.6.11 Child Lock

Use Child Lock function to prevent children from tampering with the machine. Thus you 

can avoid any changes in a running programme.

C

If the Programme Selection knob is rotated when the child lock is active, "Child Lock Enabled 

LED" will flash 3 times. The Child Lock does not allow any change in the programmes or the 

selected speed.
Even if another programme is selected with the Programme Selection knob while the Child 

Lock is active, previously selected programme will continue running.
When the Child Lock is active and the machine is running, you can switch the machine to 

Pause mode without deactivating the Child Lock by turning the Programme Selection knob to 

On / Off position. When you turn the Programme Selection knob afterwards, the programme 

will resume.

To activate the Child Lock:

Press and hold Speed and Delayed Start buttons for 3 seconds. While you are holding for 

3 seconds, the "Child Lock Enabled LED" will flash. You can release the buttons when the 

LEDs become permanently on.

To deactivate the Child Lock:

Press and hold Speed and Delayed Start buttons for 3 seconds while any programme is 

running. While you are holding for 3 seconds, the "Child Lock Enabled LED" will flash. You 

can release the buttons when the LED turns off completely.

C

In addition to the method above, to deactivate the Child Lock, switch the Programme 

Selection knob to On / Off position when no programme is running, and select another 

programme.
Child Lock is not deactivated after power failures or when the machine is unplugged.

4.6.12 Progress of programme

Progress of a running programme can be followed from the Programme Follow-up 

indicator. At the beginning of every programme step, the relevant indicator light will turn 

on and light of the completed step will turn off.

You can change the speed settings without stopping the programme flow while the 

programme is running. To do this, the change you are going to make must be in a step after 

the running programme step. If the change is not compatible, relevant lights will flash for 3 

times.

C

If the machine does not proceed to the spinning step, the Rinse Hold function might be 

active or the automatic unbalanced load detection system might be activated due to the 

unbalanced distribution of the laundry in the machine.