Beko WTIK76121, User Manual

25 / EN

Washing Machine / User’s Manual

2.  Remove the nuts of the water intake hoses 

to access the filters on the water intake 

valves. Clean them with an appropriate 

brush. If the filters are too dirty, take them 

out by means of pliers and clean them.

3.  Take out the filters on the flat ends of the 

water intake hoses together with the gaskets 

and clean thoroughly under running water.

4.  Replace the gaskets and filters carefully in their 

places and tighten the hose nuts by hand.

4.4.5 Draining remaining water 

and cleaning the pump filter

The filter system in your machine prevents 

solid items such as buttons, coins and fabric 

fibers clogging the pump impeller during 

discharge of washing water. Thus, the water 

will be discharged without any problem and the 

service life of the pump will extend.
If the machine fails to drain water, the pump 

filter is clogged. Filter must be cleaned 

whenever it is clogged or in every 3 months. 

Water must be drained off first to clean the 

pump filter.
In addition, prior to transporting the machine 

(e.g., when moving to another house) and in 

case of freezing of the water, water may have 

to be drained completely.

A

WARNING

•  Foreign substances left in the pump 

filter may damage your machine 

or may cause noise problem.

In order to clean the dirty filter and discharge 

the water:
1.  Unplug the machine to cut off the supply 

power.

A

WARNING

•  Temperature of the water inside the 

machine may rise up to 90 ºC. To avoid 

burning risk, filter must be cleaned after 

the water in the machine cools down.

2.  Some of our products have emergency 

draining hose and some does not have. 

Follow the steps below to discharge the 

water.

Discharging the water when the product has 

an emergency draining hose:

a.  Pull the emergency draining hose out from 

its seat

b.  Place a large container at the end of the 

hose. Drain the water into the container by 

pulling out the plug at the end of the hose. 

When the container is full, block the inlet 

of the hose by replacing the plug. After 

the container is emptied, repeat the above 

procedure to drain the water in the machine 

completely.

c.  When draining of water is finished, close the 

end by the plug again and fix the hose in its 

place.

d.  Turn the pump filter to take it out.
3.  Clean any residues inside the filter as well 

as fibers, if any, around the pump impeller 

region.

4.  Install the filter.
5.  If the filter cap is composed of two pieces, 

close the filter cap by pressing on the tab. 

If it is one piece, seat the tabs in the lower 

part into their places first, and then press 

the upper part to close.