EN / 23
Washing Machine / User’s Manual
6.8 Electrical requirements
a) Before you insert the plug into the wall socket make sure that the
voltage and the frequency shown in the rating label corresponds to
your electricity supply.
b) We recommend that this appliance be connected to the mains
supply via a suitable switched and fused socket in a readily
accessible position.
c) Should the mains lead of the appliance become damaged or need
replacing at any time, it must be replaced by a special purpose made
mains lead which can only be obtained from an Authorised Service
Agent.
WARNING!
• This appliance must be earthed .
CAUTION!
• If the fitted moulded plug is not suitable for your socket,
then the plug should be cut off and an appropriate plug
fitted.
- Balance the machine by adjusting the feet.
- Check for any play by pressing the product from upper
diagonal edges.
- Otherwise, the product may move from its place and
cause crushing and vibration problems.
• Destroy the old plug, a cut off plug with a bare cord could
cause a shock hazard if inserted into a socket elsewhere in
the house.
• The moulded plug on this appliance incorporates a 13A
fuse. Should the fuse need to be replaced an ASTA
approved BS1362 fuse of the same rating must be used.
- Do not forget to refit the fuse cover. In the event of
losing the fuse cover, the plug must not be used until a
replacement fuse cover has been fitted.
- Colour of the replacement fuse cover must be the same
colour as that visible on the pin face of the plug.
- Fuse covers are available from any good electrical store.
