Beko WTV8725XCW1, User Manual

21 / EN

Washing Machine / User Manual

C

INFORMATION

•  Foreign metal substances will cause rust 

stains in the drum. Clean the stains on the 

drum surface by using cleaning agents for 

stainless steel.

A

WARNING

•  Never use steel wool or wire wool. These 

will damage the painted, chromated and 

plastic surfaces.

4.4.3 Cleaning the body 

and control panel

Wipe the body of the machine with soapy 

water or non-corrosive mild gel detergents as 

necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the 

control panel.

4.4.4 Cleaning the water intake filters

There is a filter at the end of each water intake 

valve at the rear of the machine and also at 

the end of each water intake hose where they 

are connected to the tap. These filters prevent 

foreign substances and dirt in the water to 

enter the washing machine. Filters should be 

cleaned as they do get dirty.

1.  Close the taps.
2.  Remove the nuts of the water intake hoses 

to access the filters on the water intake 

valves. Clean them with an appropriate 

brush. If the filters are too dirty, remove 

them from their places with a pliers and 

clean in this way.

3.  Take out the filters on the flat ends of the 

water intake hoses together with the gaskets 

and clean thoroughly under running water.

4.  Replace the seals and filters carefully and 

tighten their nuts by hand ensuring there are 

no leaks.

4.4.5 Draining remaining water 

and cleaning the pump filter

The filter system in your machine prevents 

solid items such as buttons, coins and fabric 

fibres clogging the pump impeller during 

discharge of washing water. Thus, the water 

will be discharged without any problem and the 

service life of the pump will extend.
If the machine fails to drain water, the pump filter 

is clogged. Filter must be cleaned whenever it 

is clogged or in every 3 months. Water must be 

drained off first to clean the pump filter.
In addition, prior to transporting the machine 

(e.g., when moving to another house) and in 

case of freezing of the water, water may have 

to be drained completely.

A

 CAUTION!

•  Foreign substances left in the pump filter 

may damage your machine or may cause 

noise problem.

•  If the product is not being used, shut the 

tap shut, remove mains pipe and drain the 

water inside the machine against any likely 

freezing.

•  After each use, turn off the water tap to 

which the mains hose is connected.

In order to clean the dirty filter and discharge 

the water:
1  Unplug the machine to cut off the supply 

power.

A

 CAUTION!

•  Temperature of the water inside the 

machine may rise up to 90 ºC. To avoid the 

burning risk, clean the filter after the water 

inside the machine is cooled down.

2.  Open the filter cover.