57 / EN
Washing Machine / User’s Manual
4.3.8.2 Functions/Programmes Selected by Pressing the Function Keys for 3 Seconds
• Drum C
This programme is selected by pressing the 1st auxiliary function key for 3 seconds.
Run this programme with the machine unloaded on a regular basis (once a month or every two months)
to clean the drum. To obtain better results, put powder lime-scale remover for washing machines into the
detergent compartment no. “2”. This programme contains a drying step that runs after the drum cleaning step
to dry the inside of the machine.
C
This is not a washing programme. It is a maintenance programme.
Do not run the programme when there is something in the machine. If you try to do so, the machine detects that there is
load inside and aborts the programme.
• Child lock
Use Child Lock function to prevent children from tampering with the machine. Thus you can avoid any changes
in a running programme.
C
You can switch on and off the machine with On / Off button when the Child Lock is active. When you switch on the machine
again, programme will resume from where it has stopped.
When the Child Lock is enabled, an audio warning will be given if the buttons are pressed. Audio warning will be canceled if
the buttons are pressed five times consecutively.
To activate the Child Lock:
Press and hold
Auxiliary Function button 2
for 3 seconds. After the countdown as
“CL 3-2-1"
on the
display is over, "CL On" symbol appears on the display. Release
Auxiliary Function button 2
when this
warning is displayed.
To deactivate the Child Lock:
Press and hold
Auxiliary Function button 2
for 3 seconds. After the countdown as
“CL 3-2-1"
on the
display is over, "CL Off" symbol disappears.
• An (Ant)
This function is selected when the 4th auxiliary function is pressed and held for 3 seconds and the programme
follow-up light for the relevant step turns on.
When selected, it aerates the laundry for up to 8 hours at the end of the programme to prevent creasing. You
can cancel the programme and take your laundry out at any time during the 8-hour duration. Press the function
selection key or the machine on/off key to cancel the function. The programme follow-up light will remain on
until the function is canceled or the step is complete. If the function cannot be cancelled, it will be active in the
subsequent washing cycles as well.
4.3.9 End Time
Time display
Remaining time for the completion of the programme while it is running is displayed as “01:30” in hours and
minutes format.
C
Programme time may differ from the values in section "Programme and consumption table" depending on the water
pressure, water hardness and temperature, ambient temperature, amount and the type of laundry, auxiliary functions selected
and the changes at the mains voltage.
With the
End Time
function, the startup of the programme may be delayed up to 24 hours. After pressing
End
Time
button, the programme's estimated ending time is displayed. If the
End Time
is set,
End Time
indicator
is illuminated.
1888
88:88
88
C
0
Summary of Contents for WTZ101435BI
Page 34: ......
Page 35: ...2820525943_EN 30 04 18 11 55 Washing Machine User s Manual WTZ101435BI EN Document Number ...
Page 67: ......
Page 68: ...www beko com ...
