32 / EN
Washing Machine / User’s Manual
4.6.13 Progress of programme
Progress of a running programme can be followed from the Programme Follow-up
indicator. At the beginning of every programme step, the relevant indicator light will turn
on and light of the completed step will turn off.
You can change the auxiliary functions, speed and temperature settings without stopping
the programme flow while the programme is running. To do this, the change you are
going to make must be in a step after the running programme step. If the change is not
compatible, relevant lights will flash for 3 times.
C
If the machine does not pass to the spinning step, Rinse Hold function might be active or
the automatic unbalanced load detection system might be activated due to the unbalanced
distribution of the laundry in the machine.
4.6.14 Loading door lock
There is a locking system on the loading door of the machine that prevents opening of the
loading door in cases when the water level is unsuitable.
Loading door light will start flashing when the machine is switched to Pause mode.
Machine checks the level of the water inside. If the level is suitable, Loading Door light
illuminates steadily within 1-2 minutes and the loading door can be opened.
If the level is unsuitable, Loading Door light turns off and the loading door cannot be
opened. If you are obliged to open the Loading Door while the Loading Door light is off, you
must cancel the current programme. See. "Cancelling the programme"
4.6.15 Changing the selections after programme has started
Switching the machine to pause mode
Press the Start / Pause button to switch the machine to pause mode while a programme
is running. The light of the step which the machine is in starts flashing in the Programme
Follow-up indicator to show that the machine has been switched to the pause mode.
Also, when the loading door is ready to be opened, Loading Door light will also illuminate
continuously in addition to the programme step light.
Changing the auxiliary function, speed and temperature
Depending on the step the programme has reached, you can cancel or select the auxiliary
functions. See, "Auxiliary function selection".
You can also change the speed and temperature settings. See, "Spin speed selection" and
"Temperature selection".
C
If no change is allowed, the relevant light will flash 3 times.