page 7
© 2007 bel canto design, Ltd.
CD-2 User’s Guide 0607revA
CD-2 Front Panel Operation
CD-2 Operating Mode Display:
Several Operating Modes are displayed
using the left-most 7-segment display:
Two Vertical Lines Indicate Pause, a
Square indicates Stop, a Blinking
Segmented Square indicates Play.
Standby is indicated by two dashes - -
CD-2 in Fixed Output Mode
(Fixed/Variable IN):
Upon application of power the CD-2
goes through a display check and
comes up in Standby, indicated by two
dashes on the display - -.
Place a CD on the CD-2 and then place
the magnetic puck on the CD. It will
automatically center and clamp itself in
place.
Press the center of the front panel control
for 2-3 seconds, you will then see the
firmware revision displayed for a couple
of seconds and the CD will spin while 4
dashes are displayed. Once the CD
Table Of Contents is read the display
will indicate the total CD time and the
number of tracks.
A 01 display indicating track 1 with 2
vertical dashes || in the left hand mode
indicator display will indicate that the
CD-2 is in Pause mode and is ready to
play the CD.
Initiate
Play
by pressing the front panel
control once. Scan to a new track by
rotating the control. This works while in
Pause, Play or Stop modes.
To
Pause
while playing press the con-
trol once.
To
Stop
at any time press the control
twice. The CD-2 will remain on the cur-
rent track on re-start the track when Play
is started.
A center press on the control will be
acknowledged by the display brighten-
ing momentarily.
When in Play mode the mode indicator
shows a square with sequenced blinking
segments.
Stop is indicated by a stationary square.
The CD will be stopped. In Play and
Pause modes the CD will continue to
rotate.
CD-2 in Variable Output Mode
(Fixed/Variable OUT):
Operation will be the same as above
accept that rotating the front panel con-
trol while in Stop or Play mode will indi-
cate the volume level and then change
the volume up or down as the control is
rotated.
Rotating the control in Pause mode will
change the track number to be played.
The volume display will stay lit for sever-
al seconds and then the display will go
back to the mode indicator/track num-
ber display.
