BM-A1-64DANTE User Manual v1.1
10
Bel Digital Audio Ltd
be found via our support page (see
http://www.
beldigital.com/support.php
).
When connected to the Dante network, the
confidence monitor will be identified in Dante
Controller.
In addition to being able to utilise the onboard 64x64
matrix, it is also possible to reconfigure the monitor
to operate at other sample rates (up to 96 kHz) by
use of the Dante Controller application.
All settings are stored on the BM-A1-64DANTE
and are retained upon power-down. Therefore if the
selection of channels to be fed to the Dante monitor
does not change then there is no requirement to run
the Dante Controller application again.
Dante Controller
When shipped, the BM-A1-64DANTE is configured
to monitor the first 64 channels on a Dante network
and operate at a sampling frequency of 48 kHz.
However a Dante network may have a channel count
of up to 512 channels, with multiple 3rd party Dante
devices connected to the network. It is therefore
possible to configure the Dante monitor so that it
monitors any of these sources (up to a total of 64 at
48 kHz) by use of the internal routing matrix.
Access to this routing matrix is via the Audinate
Dante Controller software package.
As the BM-A1-64DANTE is a monitoring device, it
is highly likely that the Dante Controller is already
installed and operating on the existing Dante
network. However, if you do require further details
on the operation of Dante Controller then these can
Configuration
