BelAir20E User Guide
System Settings
April 2, 2012
Confidential
Document Number BDTM02201-A01 Standard
Effective SNTP Timeoffset:
===========================
SNTP Timeoffset origin: SNTP schema
SNTP Time Offset: 6:00
Effective SNTP server:
======================
SNTP Servers origin: SNTP schema
Active Server: Primary - 0.pool.ntp.org
SNTP server Primary : 0.pool.ntp.org
SNTP server Secondary : 1.pool.ntp.org
DHCP timeserver Primary : 0.0.0.0
DHCP timeserver Secondary: 0.0.0.0
GPS Coordinates
/system/set coordinates [latitude <-90,+90> ] [longitude <-180,+180>]
/system/show coordinates
These commands allow you to specify the exact geographic location of a BelAir
unit. You can then use the Global Positioning System (GPS) coordinates to
locate a unit in the field.
The
show coordinates
command displays the unit’s coordinates.
Example
/system# set coordinates latitude 76 longitude -120
/system# show coordinates
latitude: ............... 76.000000
longitude: .............. -120.000000
LED Control
You can use the following commands to control the LED behavior of the
BelAir20E:
•
•
“LED Enable or Disable” on page 53
Find Me Function
/system/find-me {start|stop}
This command helps you determine the physical location of a unit.
When you start the
find me
function, the unit’s power LED starts a green and
red flashing cycle.
LED Enable or Disable
/system/show visual-indicators-status
/system/set visual-indicators {off | enable}
This command lets you turn enable or disable the LEDs of a unit.
