BelAir20E Quick Install Guide
Getting Started
March 23, 2012
Confidential
Page 3 of 8
Document Number BDTQ02201-A04 Standard
Hardware
Description
Internet Port
The
Internet
port of the BelAir unit supports IEEE 802.3af or IEEE 802.3at
Power over Ethernet (PoE) from a 48 V DC switch or power injector:
• Use IEEE 802.3af PoE if only connecting to the
Internet
port.
• Use IEEE 802.3at PoE if connecting to the
Internet
port and any of the
LAN
ports.
The PoE switch or power injector must meet local and national regulatory
requirements.
Power Connector
The BelAir unit does not have a power switch. It is powered on when
connected to a power source. The power adapter automatically adjusts to any
voltage between 100~240 volts at 50 or 60 Hz. The BelAir unit draws up to
0.35 A at 48 V DC (16.8 W).
Reset Button
This button is used to restore the factory default configuration using a paperclip
or pen tip. If you hold down the button for 15 seconds or more, until all of the
LEDs turn off, any configuration changes you may have made are removed, and
the factory default configuration is restored to the BelAir20E.
Warning
The AC Power Adapter relies on the rated fuse or circuit
breaker of the wall outlet (15 A in North America, 10 A in
Europe).
