insta-
KLEEN™ MANUAL
18
Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681
1MANUL334
Installation
Guide Rails
1) Position the passenger side Y-Section at 23-
1/4” (590mm) from the center of the doorway to the
inside surface of the inside Guide Rail as shown below.
Note:
All placement measurements are taken from the surfaces of the angle, not the plastic.
The outside (driver side) guide rail is measured from the inside surface of the inside guide rail 14-
9/16” (370mm). When the plastic is put on the guide rail opening will be 13” (330mm) as shown
above.
After installing the Y-Section, you can begin to install the center sections and exit section.
2) By using the alignment pins on the entrance end of all center sections, slide the pin into the exit
end legs of the previously installed sections. Repeat until all sections are in place.
3) Once all pieces are in place, confirm that they are all properly aligned and lag them to the floor.
23-
1/4”
Centerline
of
Doorway
14-9
/16”
13”
13”
23-1/
4”
14-9/
16”
Centerline
of
Doorway
Left Hand Drive
Right Hand Drive
48
”
Centerline
of
Doorway
96
”
Dual Rear Tire Width
(370mm)
(590mm)
(330mm)
(590mm)
(370mm)
(330mm)
(1219mm)
(2438mm)
(1111mm)
(2133mm)
43-
3/4”
Centerline
of
Doorway
84”
Car Width
Summary of Contents for insta-KLEEN
