Belarus 1025/1025.2/1025.3
Section H. Adjustments
H5
Wheels
setting
diagram
Opening number
I
II
III
Dimension
А
280
335
390
1460
1570
1680
1620
1730
1840
11. Repeat operations on the right side
Ap = Al.
12. Make adjustment of front wheels toe-
in. (see Recommendations below).
13. Tighten nuts of steering tie-rod tube.
9. Install and fix cylinder pin (2) in
opening of arm (1) in accordance with
table above.
10. install and tighten wedges and cover
of the adjusting screw.
Note:
When rearranging wheels from
one side to another, reinstall tires to
provide correct direction of tread
pattern.
Setting front wheels span of tractors
Belarus-1025.2/1025.3
(Beam-type FDA)
The span of tractor front wheels is
adjusted only by rearrangement of
wheels within 1420...2000 mm.
To adjust wheels span perform the
following operations:
•
Brake tractor using parking brake. Place
wedges in front of and from back of rear
wheels;
•
Jack up front tractor section (or front
wheels one by one) to provide
clearance between wheels and ground;
•
Dismount front wheels;
•
Unscrew nuts, fixing wheel rim to disk.
Depending on the wheels span required,
set corresponding mutual position of the
rim and disk, as shown in the diagram.
Pay attention to direction of wheels
rotation – it should coincide with
direction of the arrow on the tire side.
Summary of Contents for 1025 2008
Page 205: ......
