Belarus 1025/1025.2/1025.3
Section D. Controls and instruments
D24
Control of RMU with hydraulic lift
RMU is controlled by two levers (1)
and (2), located in the cabin on the right-
hand control panel.
Power control handle (1) is situated
closest to the operator seat and has the
following positions:
•
Extreme front — maximum plough
depth («9»).
•
Extreme back — minimum plough
depth («1»). Range of handle
positions is marked by figures from
«1 » to«9».
Position control handle (2) has the
following positions:
•
Extreme back («1») — transport RMU
position.
•
Extreme front («9») — minimum
machine height above soil.
Maximum height of the machine lift using
handle (2) is limited by adjusting stop (3).
Note:
Mixed control is made by limiting
machine tools’ penetration by handle
(2), when operating in the power control
mode.
Control of the hydraulic system pump
The control lever has two positions:
•
«The pump is on» - upper position;
•
«The pump is off» - lower position.
Important!
Switch off the pump on cold
diesel start or during maintenance.
Switch on the pump at minimum diesel
idle revolutions.
Summary of Contents for 1025 2008
Page 205: ......
