Belarus 1025/1025.2/1025.3
Section E. Preparation for operation
When the heater is switched on, scotched
plug ignites fuel inside suck-in manifold
and heats up air sucked in cylinders.
With stable low temperatures use winter
grades of oil in diesel casing, gear box
and hydraulic system in compliance with
the present manual directions.
Keep storage batteries fully charged.
Use pure winter-grade diesel fuel with no
water ingredients.
IMPORTANT!
Fill fuel tanks at the end of
each working day to exclude condensate
formation inside tanks.
The order of diesel start.
1. Fill the tank of electric torch heater with
diesel fuel.
2. Disconnect oil pump drive of the
hydraulic system to reduce resistance to
crankshaft turning-through.
3. Raise (shut down) water radiator
shutter to heat up diesel faster.
4. Check level of oil in diesel casing and
cooling fluid in the radiator.
E3
5. Engage the tractor parking brake.
6. Set GB gear and range shifting lever to
“neutral” position.
7. Set PTO control lever to position “Off”.
8. Switch on “Ground”.
9.
Set lever of fuel supply control to
middle position.
10. Press clutch pedal.
11. Turn key (1)of starter switch to position
«I». Press and hold key (2) of ETH
switching. In this case control lamp (3)
of easy start on the block of control
lamps should light. Keep key (1) in
this position until the lamp starts
flashing. When control lamp (3) starts
flashing diesel is ready for starting.
Turn key of starter switch to position
“II” ( “Start”) and make the start as
shown above for starting diesel under
normal conditions. Release key (2)
after diesel start.
12. Release clutch pedal. Heat up the
diesel.
13. Check instruments’ functioning,
adjust position of water radiator
shutter to maintain normal heat
mode.
Summary of Contents for 1025 2008
Page 205: ......
