Belarus 1025/1025.2/1025.3
Section E. Preparation for operation
E13
e) after gimbal drive is installed make sure,
elements of the telescopic connection do
not abut against gimbal drive in end
positions of the machine in relation to
tractor; minimum overlap of gimbal drive
telescopic section should be 110-120
mm, as with lesser overlap the gear
may be disconnected.
Length of spring (1) of an agricultural
machine safety clutch should be
adjusted so that during overloads cam
clutches (2 and 3) could turn one
against another. Excessive tightness of
the spring leads to non-functioning of
the clutch and overloads of gimbal gear
and PTO.
Engage independent PTO drive at
minimum diesel speed or with diesel shut
down. Engage synchronous PTO drive
with diesel in operation and smooth
clutch shifting.
When tractor operates without using
PTO, be sure to put PTO control lever to
position “PTO is on”, coupling for
switching two-gear PTO drive – to
position (I) (540 rev/min), and lever for
shifting from independent to synchronous
PTO drive – to the middle (neutral)
position.
Summary of Contents for 1025 2008
Page 205: ......
