1523.5-0000010 OM
14
Table 1.1 finished
Parameter
(specification) designation
Parameter value for tractor
“BELARUS -1523.5»
20 Operating equipment:
а
) rear power take-off shaft:
In subsection 3.2.7 “PTO use”
b) front power take-off shaft:
In subsection 3.2.7 “PTO use”
c) rear lift linkage:
1) load-lifting capacity of rear lift linkage on
the suspension axle, kg, at least
6500
2) rear lift linkage lifting time from lower-
most to uppermost position with test load
on the suspension axle, s, at least
5
d) drawbar hitch:
In section 4 “Coupling of implements”
_____________________________________________________________________
________________________________________
1)
Engine parameters, not specified in table 1.1, shall comply with 260 S3
В
– 0000100
OM document.
2)
For referential use.
3)
Without a creeper. Installation of a creeper against order provides additional four
speeds for forward travel and four speeds for the reverse.
4)
To be specified depending on configuration.
5)
With ballast mounted.
6)
Without ballast.
Note – In Table 1.1 the number of gears and tractor travel speed at engine shaft rated
speed are specified for tractors «BELARUS-1523.5» with installed GB 16
х
8 (basic configu-
ration). The number of gears and travel speed for tractors «BELARUS-1523.5» with in-
stalled GB 24
х
12 (custom design) are specified in subsection 2.27 «Gear and range shift-
ing of GB 24
х
12».
